CANADIAN STANDARD _DIGITAL
To measure the freeness and dewatering rate of suspensions according to Canadian standards.
BCT_03 Box Compression Tester
BCT_03 Box Compression Tester
9770A or 9971B Side Wall Fixture Change Part
These change parts are used to test the outside mobility/lubricity of a can sample.
Miniature Force Sensors Series R04
Extremely compact force measurement sensor for tensile and compressive loads in applications with limited space.
PFI MILL
For grinding pulp in laboratory quantities under standardized conditions (30 g).
LSD_01 Leak Tester
LSD 01 Leak Tester is applicable in leak testing of pouches, bottles, pipes, cans and boxes of foodstuff…
9791A Bottom Fixture Change Part
These change parts are used to test the bottom mobility/lubricity of a can sample.
Push Pull Sensors Series R05
Series R05 fully enclosed smart sensors are designed for pull / push measurements.
DISINTEGRATOR
For disintegration of pulp suspensions according to standardized conditions.
LSD_01A Leak Tester
LSD_01A Leak Tester is applicable in leak testing of pouches, bottles, pipes, cans and boxes of foodstuff…
9818 Change Part
9818 Change Part — supplied and supported in India by Polytech Instruments (ALTEK Company TECH Products).
Universal Torque Sensors Series R50
Measure bi-directional torque for a wide variety of applications. Contains a chuck for samples up to 1/2" (12.
WATER ABSORPTION TESTER
To determine the water absorption and suction time of tissue samples.
LSD_02 Leak And Seal Strength Detector
LSD_02 Leak and Seal Strength
9793A Flat Sample Fixture Change Part
These change parts are used to test the surface mobility/lubricity of a can body blank or any other flat sample.
Universal Torque Sensors Series R51
A great solution for general bi-directional torque testing applications requiring different sample sizes.
WATER RETENTION CENTRIFUGE
Centrifuge for water retention tests of pulp samples.
FST_01 Film Free Shrink Tester
FST_01 Film Free Shrink Tester
9752 Change Part
The 9752 Change Parts hold a round end or can in place as the full-opening end or tab is being tested.
Torque Sensor For Tool Calibration Series R52
Calibrate torque tools with this torque measurement sensor, or use it as a component of a torque testing system.
BAUER MCNETT
To determine the fiber length of pulp by classification.
RUB_02 Rub Tester
RUB_02 Rub Tester is applicable in abrasion resistance test of printed materials, PS boards and coating layers of other…
High Temperature Circulating Bath
Model LBC-A10 has a capacity of 22 litres and consists high Temperature Circulating Bath that is best suited for…
9820 Change Part
The 9820 Change Part holds a straight wall can in place as it is being pressurized.