Manual colony counter
Manual colony counter LMCC Series is a reliable unit for rapid and accurate manual colony counting with multi-mode…
9776_60 or 9776_160 Low and High Pressure Calibration Guages
The 9776 Pressure Calibration Gauge is used to verify the calibration of a gauge or digital readout on an air-operated…
DEVELOPING TANK
CO.FO.ME.GRA. produces also a Plate Developing Tank with temperature control, mixing pump and quick discharging bath.
SCHOPPER RIEGLER_DIGITAL
To determine the freeness and the drainage properties of fiber and pulp suspensions.
BCT_01 Box Compression Tester
BCT_01 Box Compression Tester
Colony Counter
Automatic Colony Counter is equipped with high resolution CCD Camera lens.
9819 Axial Load Tester Calibration Cell
The 9819 Axial Load Tester Calibration Cell is used to calibrate the Altek family of Axial Load Testers.
BCT_02 Box Compression Tester
BCT_02 Box Compression Tester
9842 Digital Pressure Calibrator
The 9842 Digital Pressure calibrator is used to calibrate the Altek family of Buckle and Panel Testers, including the…
BCT_03 Box Compression Tester
BCT_03 Box Compression Tester
9770A or 9971B Side Wall Fixture Change Part
These change parts are used to test the outside mobility/lubricity of a can sample.
Miniature Force Sensors Series R04
Extremely compact force measurement sensor for tensile and compressive loads in applications with limited space.
PFI MILL
For grinding pulp in laboratory quantities under standardized conditions (30 g).
LSD_01 Leak Tester
LSD 01 Leak Tester is applicable in leak testing of pouches, bottles, pipes, cans and boxes of foodstuff…
9791A Bottom Fixture Change Part
These change parts are used to test the bottom mobility/lubricity of a can sample.
Push Pull Sensors Series R05
Series R05 fully enclosed smart sensors are designed for pull / push measurements.
LSD_01A Leak Tester
LSD_01A Leak Tester is applicable in leak testing of pouches, bottles, pipes, cans and boxes of foodstuff…
9818 Change Part
9818 Change Part — supplied and supported in India by Polytech Instruments (ALTEK Company TECH Products).
Universal Torque Sensors Series R50
Measure bi-directional torque for a wide variety of applications. Contains a chuck for samples up to 1/2" (12.
LSD_02 Leak And Seal Strength Detector
LSD_02 Leak and Seal Strength
9793A Flat Sample Fixture Change Part
These change parts are used to test the surface mobility/lubricity of a can body blank or any other flat sample.
Universal Torque Sensors Series R51
A great solution for general bi-directional torque testing applications requiring different sample sizes.
FST_01 Film Free Shrink Tester
FST_01 Film Free Shrink Tester
9752 Change Part
The 9752 Change Parts hold a round end or can in place as the full-opening end or tab is being tested.